Table of Contents
Advertisement
Palette VL
HOOK-UP
1. Connecting Console Components
To connect console components, do the following:
Step 1. At console rear panel, connect power supply cord (included).
Step 2. Connect monitor or touchscreen (sold separately).
Step 3. Install gooseneck lamps (sold separately).
Step 4. Connect PS2-compatible peripherals (i.e. mouse, keyboard, etc.).
Step 5. Connect USB-compatible peripherals as needed.
2. Connecting to System
The console provides four standard XLR 5-pin connectors for connecting to DMX512 devices. Each connector
supports one DMX512 universe of 512 DMX channels. Connect DMX512 devices as shown in Figure 2-1.
Remote Focus Unit (RFU)
The Remote Focus Unit (sold separately) is an optional
remote Ethernet device that can be connected to the
console using either a wired or wireless configuration.
The two connection options are as follows:
• CAT5 twisted-pair Ethernet cable from the back of the
console to the RFU. (The configuration can be routed
through walls, hubs, switches, etc.)
• CAT5 twisted-pair Ethernet cable from the back of the
console to a wireless Access Port; and then from the
Access Port though the air to the RFU with wireless
receiver.
USB
Power
Keyboard
Mouse
Serial (DB-9M)
Figure 2-1: Console Rear Panel
L
C
IGHTING
ONTROL
Printer (DB-25F)
C
US
Network (RJ-45)
Monitor (HDB-15F)
Figure 2-2: Remote Focus Unit Connection
C
I
& S
ONSOLE
NSTALLATION
ETUP
DMX512 Out (XLR-5M)
To RFU
RFU
Wireless
Access
or
CAT5 Cable
Connecting Console Components
G
UIDE
Port
11
Advertisement
Table of Contents
