Additional Parameters - Siemens sitrans LR 400 Instruction Manual

Additional Parameters

2. Display
2.1: Multi-display (F = level in m
Two-line display shows two measured values. The values to be shown are set using
Parameter 4.5. 1 . 1 (Line 1 Local) and in Parameter 4.5.1.4 (Line 2 Local).
2.2: Level (F = m)
Current level of material (set unit using Length Unit in Auto-Setup)
3
2.3: Volume (F = m
Volume of material (set unit using Parameter 4.1.2 [Volume Unit])
2.4: Mass (for qualified personnel only)
This parameter is for Factory Authorized Personnel only.
2.5: Current Output
Analog output displayed in mA
When the device electronics are working properly, the displayed mA current value will
correspond to the measured output current.
2.6: Digital Output
State of digital output
3. Diagnostics
3.1: Status
The Status parameters display the current status messages of the device. Parameter 3. 1 .1
is always accessible; other parameters (Parameter 3.1.x) appear in the appropriate order
if they contain error messages.
3.1.1: Wear
3.1.1.1: Operating Hours
Total previous operating time of the device in hours (approximate value)
Page 30 SITRANS LR 400 (Solids) – INSTRUCTION MANUAL
Signal to noise ratio in db)
)
7ML19985JC02