Installation
Preparing the worktop
Make the worktop cut-out as shown
in the "Building-in dimensions".
Observe the safety distances in all of
the applicable CombiSet operating
and installation instructions.
Wooden worktops
Seal the cut surfaces on wooden
worktops with a suitable sealant to
avoid swelling caused by moisture.
The sealant must be heat-resistant.
Make sure the sealant does not
come into contact with the top
surface of the worktop.
32
Installing the downdraft
extractor
Install the downdraft extractor first and
then the CombiSets.
Undo the relevant housing screws on
the front of the downdraft extractor
and loosely attach the fixing plate.
Depending on the building-in
position, bend the guide tab at the
top and the plate's side fixing tab
90°:
a Right mounted fan,
b Left mounted fan.