Bosch ARD-FPBEW2-IC Installation Manual page 14

14
en | Introduction
– It is recommended to use the index finger or the middle finger
when scanning the fingerprint. The authentication rate can be
reduced if it is difficult to place another finger at the center of
fingerprint sensor accurately.
Fingerprint enroll method
1. Place the finger with the fingerprint to be registered on the
fingerprint authentication unit and press the finger gently for better
authentication.
2. After a beep sounds, scan the fingerprint of the registered finger
again (scan the fingerprint of a finger to be registered twice).
Cautions for enrolling a fingerprint
When a fingerprint is recognized, it is compared with the initially
registered fingerprint, so the initial fingerprint enroll is the most
important. Pay attention to the following matters when enrolling the
fingerprint:
1. Place the finger deep enough to contact with the sensor
completely.
2. Place the center of the fingerprint in the center of the sensor.
3. If a finger has a cut or the fingerprint is blurry, select another finger
for the fingerprint.
4. Scan the fingerprint correctly without moving according to the
instruction on the screen.
5. If you make the finger upright so that the contact area with the
sensor has decreased or the angle of finger has warped, fingerprint
authentication may not be performed.
2018-02 | ARD-FPBEW2-IC |
FPBE W2 Fingerprint
Bosch Access Systems GmbH
Reader