GE C30 Instruction Manual page 55

3 HARDWARE 3.1 DESCRIPTION
3
Figure 3–11: EXAMPLE OF MODULES IN F AND H SLOTS
The torque used to connect the terminal blocks to the back of the relay chassis (screws a, b, c shown) is 9 inch-pounds. For
the connections to the terminal blocks (rows 1 to 8), use a minimum of 17 inch-pounds. During manufacturing, the power
supply and CPU modules are installed in slots B and D of the chassis with 13 inch-pounds of torque on the screws at the
top and bottom of the modules.
GE Multilin C30 Controller System 3-9