After Use - Silvercrest SDBE 2600 A1 Operating Instructions Manual

■ Move the temperature control
position.
■ Stand the steam iron only on the base

After use

■ Remove the power plug from the mains power
socket.
■ Empty the water tank and clean the sole of the
iron .
■ Place the cooled-down steam iron on the base
Automatic descaling function
(ANTICALC)
There is a descaling cartridge in the water tank that
helps reduce the build-up of limescale.
This descaling cartridge is a permanent fixture in
the water tank and cannot be replaced.
Drip-Stop function
With conventional steam irons, water can drip from
the sole of the iron
This iron, however, possesses a new feature: the
DRIP-STOP function (
peratures the iron automatically switches off the
steam-blast function.
Then set a suitable temperature with the tempera-
ture control . As soon as this is reached, steam
production is resumed.
Automatic switch-off
This steam iron is fitted with an automatic switch-off
system. This stops the iron from heating up.
If the iron is resting on its sole
for about 30 seconds, there will be a warning beep
and the control lamp for the automatic switch-off
flashes. The iron will stop heating up. To deactivate
the automatic switch-off, lift up the iron and move
it gently from side to side. The control lamp for the
automatic switch-off
heat up again.
■ 8 │ GB │ IE │ NI
to the "MIN"
.
at low temperatures.
). At low tem-
and is not moved
goes out and the iron will
If the iron is resting on its base
for about 8 seconds, there will be a warning beep
and the control lamp for the automatic switch-off
flashes. The iron will stop heating up. To deactivate
the automatic switch-off, lift up the iron and move
it gently from side to side. The control lamp for the
automatic switch-off
heat up again.
NOTE
The automatic switch-off is not intended as a
.
substitute for removing the plug from the mains
power! This is merely intended to reduce the fire
hazard if you forget to switch of the iron!
Cleaning
Self-cleaning function
■ Fill the water tank to the "MAX" marking.
■ Insert the plug into the mains power socket.
■ Move the temperature control
position.
■ Set the steam control
power.
■ Allow the steam iron to heat up until the heat
control lamp
again.
■ Hold the steam iron horizontally over a suitable
container.
■ Press and hold down the self-clean button
Move the steam iron back and forth a little.
Steam and boiling water will flow from the
steam exit holes in the sole of the iron
impurities that may be present are flushed out.
■ Release the self-clean button
of the water has flown out of the water tank.
and is not moved
goes out and the iron will
to the "MAX"
to maximum steam
goes out and then lights up
as soon as all
SDBE 2600 A1
.
. Any