Binary Output Signals - Toshiba GRT100 Series Instruction Manual

Mechanical trip
Mechanical trip
Mechanical trip
Mechanical trip
Indication reset
Signal for event record Closed when external device operated. / Initiate event record
Signal for event record Closed when external device operated. / Initiate event record
Signal for event record Closed when external device operated. / Initiate event record
(+)
()
Mechanical trip
Mechanical trip
Mechanical trip
3.2.2

Binary Output Signals

The number of output binary signals and their output terminals vary depending on the relay
models. See Appendix G for details. For all models, all outputs except the tripping command,
signal for command protections and relay failure signal can be configured.
The signals shown in the signal list in Appendix B can be assigned to the output relay
individually or in arbitrary combinations. Signals can be combined using either an AND circuit
or OR circuit with 6 gates each as shown in Figure 3.2.2. The output circuit can be configured
according to the setting menu. Appendix D shows the factory default settings.
A 0.2s delayed drop-off timer can be attached to these assigned signals. The delayed drop-off
time is disabled by the scheme switch [BOTD].
The relay failure contact closes when a relay defect or abnormality in the DC power supply
circuit is detected.
Table 3.2.2 Binary Input Signals
Signal Names Driving Contact Condition / Function Enabled
Closed when external device operated. / Initiate trip command
from operation of external device.
Closed when external device operated. / Initiate trip command
from operation of external device.
Closed when external device operated. / Initiate trip command
from operation of external device.
Closed when external device operated. / Initiate trip command
from operation of external device.
Closed to reset TRIP LED indication. / Reset indication
externally.
with external signal.
with external signal.
with external signal.
GRT100
BISW1 (Norm)
BI1
1
(Inv)
BISW2 (Norm)
BI2
1
(Inv)
BISW3 (Norm)
BI3
1
(Inv)
Figure 3.2.1 Logic Level Inversion
BI1
PLC function
BI2
Programmable
logic
BI3
1
0V
 56 
6 F 2 S 0 7 8 9
BISW
1
2
3
4
5
14
15
16
Signal No.
Protection
schemes