Cameras - Bosch MVC-FIPM Installation And Operating Manual

IP Matrix
3.6

Cameras

On this page, select the cameras that you want to integrate into your matrix system. To do
this, you must enter the IP address of the encoder unit (for example a VideoJet X40), select
the video output you require and select the stream you are using. You can integrate a
maximum of 32 cameras into the system.
With an AutoDome or a compatible unit that supports the AutoDome protocol, you can select
a preset. When you select this camera number with the keyboard, the camera moves to the
corresponding preset position.
IP Address
Enter the IP address of the encoder unit or IP camera here. Alternatively, you can perform a
network scan and select the IP address you require from the results.
1.
2.
3.
Video Input
Select the number of the video input you require from the list. The numbering follows the
labeling of the video inputs on the unit.
Stream
Select the number of the data stream you require from the list.
Preset
For an AutoDome or a compatible unit that supports the AutoDome protocol, enter the
required preset in the field.
Bosch Security Systems
www.a1securitycameras.com email: sales@a1securitycameras.com
Click the Network Scan button. The search for encoder units and IP cameras is started.
When the search has finished, a small arrow appears next to the fields for the IP
addresses.
Move the cursor over the arrow next to the IP Address field. The list of units found is
displayed.
Click the IP address you require to transfer it to the IP Address field.
Installation and Operating Manual
Available from A1 Security Cameras
Installation and Configuration | en
F.01U.082.117 | V4.0 | 2008.12
13