Chapter 2: Software Installation; Installing Motomesh Client Software On Windows Xp; Procedure 2-1 Motomesh Client Software Installation On Windows Xp - Motorola WMC6300 User Manual

Chapter 2: Software Installation

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This chapter will assist you with the Software installation portion of the process and is further
separated into two main sections: Installing MOTOMESH Client Software on Windows XP and
Installing MOTOMESH Client Software on Windows 2000.

Installing MOTOMESH Client Software on Windows XP

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The following procedure outlines the installation of the MOTOMESH client software on a typical
Windows XP platform. Some of the steps may vary slightly based on the configuration of the
individual computers.
If you are running Windows XP Service Pack 2 (SP2), Windows Firewall is
turned on by default. It is recommended that you disable the firewall when
using your Wireless Modem Card.
Procedure 2-1 MOTOMESH Client Software Installation on Windows XP
Close and exit any existing MOTOMESH applications running on the computer prior to installation.
1
Insert the Software and Documentation CD into the CD-ROM drive.
2
If the installation program does not start automatically, open the Windows Start menu. Click on Run
3
then type the following into the dialog box:
where d: specifies the CD-ROM drive and click the OK button.
Click the Next button to continue the installation process.
4
The MOTOMESH Setup dialog box will be displayed as shown in Figure 2-1.
5
6881011Y52-O August 2005
.
.
.
.
.
.
d:\setupmotomeshclient.exe
2-1
Chapter
2