4.7 Setting ECO Mode
Enabling this mode reduces the amount of electricity consumed by the unit.
Note
•
When ECO mode is enabled, the "Link Speed" setting changes as follows:
–
Link Speed: "10M/Full"
–
PC port cannot be used
•
When the ECO mode setting is changed, the unit will restart.
•
When ECO mode is enabled,
The port of the switching hub to which the unit is connected must be 10 Mbps (Fixed) / full duplex.
*1
To set
1.
In standby mode, tap
2.
Tap
or
, and then select "System Settings".
3.
Tap
or
, and then select "ECO Mode"
4.
Tap "On", and then tap "OK".
The administrator password may be required for this setting. Contact your administrator for further information. For available
*1
characters, see "5.2 Character Table for Administrator Password".
To disable ECO mode, select "Off" (default).
*2
Document Version: 2017-08
*1
is displayed in the status bar.
or
, and then select "System Settings".
.
*1
*2
4.7 Setting ECO Mode
Operating Instructions
103