Night Transfer
CAUTION!
If the DISA security is cancelled, outgoing unrestricted Exchange Line access is
available to anyone calling in on a DISA line or built-in Auto Attendant.
Night Transfer
Incoming calls to your system can be made to route and ring different destinations, based on either
two- or three-call routing (ringing) patterns (set in system programming). The Night Transfer LED
indicates the active routing pattern:
H
Night Transfer can be locked by pressing
the procedure outlined on the following page).
C
If the system has tenant service, up to four Tenant Night Transfer buttons (
can be assigned and controlled independently.
➤
To enable/disable night transfer
➤
Press
Night Transfer Lock/Unlock Password
The Night (NT) Lock/Unlock mode enables the Administrator's station or an attendant console to
lock the system into the Day, Day 2, or Night mode. By setting the system into different modes,
incoming Exchange calls can be routed to different destinations.
In order for the Administrator station or the attendant console to perform such routing, it must be
assigned with
Transfer
information.
6
Mode
DAY
DAY 2
NIGHT
Night Transfer
to toggle night transfer ON/OFF.
Night Transfer
and
NT Lock
and
buttons are allowed. Check with the system installer for any additional
Three-pattern
OFF
FLASH
ON
NT Lock (1~4)
and dialling the NT Lock password (see
NT Lock
buttons via system programming. Up to four
Strata CT System Administrator Guide October 2000
Setting System Parameters
Two-pattern
OFF
N/A
ON
Night Transfer 1~4
)
Night