Charging Your Acer N10; Setting Up Your Acer N10 - Acer N10 Manual

Plug the USB sync cable into the mini USB port on the bottom of your handheld and
plug the other end into an available USB port on your computer

Charging your Acer n10

For initial use, you need to charge your handheld for three hours. After that, you can
charge it for a few minutes each day to recharge the battery to full capacity. Normally,
you can use your handheld for 12 straight hours of operation (backlight disactive)
before you need to recharge the battery.
To charge your Acer n10
• Connect the AC adapter connector to the handheld, then plug the other end
of the AC adapter into any AC current outlet.
LED status during charging:
• Charging: LED indicator flashes green
• Charging complete: LED indicator steady green
If the battery level becomes low in the course of normal use, a status icon appears on
the handheld screen indicating low or very low battery status (refer to "Status icons"
on page 13). Perform an ActiveSync operation to back up your data; then recharge the
battery.
If your handheld shuts down (i.e., battery is completely drained out) you have about
72 hours (3 days) to recharge the battery before you lose all data on your handheld's
internal memory.

Setting up your Acer n10

After you have initially charged your handheld for three hours, you can now set it up.
Refer to the instructions below.
1 G et t i n g st a r t ed
Preparing to use your Acer n10
.
9