Fujitsu IP-HE950 Hardware User's Manual page 9

IP-HE950 Hardware User's Guide
Work time
Installation Possibility of electric shock and fire
Do not install this unit in the following places because electric shock and fire
may result from operation there:
- Extremely dusty or dirty location
Prohibited
- Wet and humid location
- Hot location, such as a place where this unit is exposed to direct
sunlight or is near heating equipment
- Near products (e.g., speakers) that generate a strong magnetic field
- Location where the temperature is too hot or cold
- In an environment with sharp temperature fluctuations
- Area with poor ventilation
- Near a fire
Possibility of electric shock, fire, and damage to this unit
Always observe the precautions given below.
There may be a hazardous situation that could lead to electric shock, fire, and
Instruction
damage to this unit.
- Always connect the power cord plug to a power receptacle for a standard
two-prong plug with ground.
- The AC power cord supplied with the unit supports voltages up to the rated
voltage of 125 V. To use the IP-HE950 above the rated voltage of 125 V,
refer to "4.2 Cable and Connector Details," and select another power cord.
- Connect the IP-HE950 to a power receptacle with a capacity of 1 A or more.
When using a power extension cable, be sure that the total current
consumption of all equipment connected to the cable does not exceed the
rated capacity of the cable. If a power receptacle with a low capacity or
capacity below the rated value is used, the power receptacle, extension
cable, or power wiring may overheat and start a fire.
- This unit is shut off by pulling out the power cord from the unit's power inlet
connector. Please install this unit where you can easily access the power
inlet connector.
Warning
Copyright 2017 FUJITSU LIMITED
viii