Samsung Officeserv 7100 Technical Manual page 73

OfficeServ 7100
TECHNICAL MANUAL
Set USER=VoIP Networking and choose the IP trunk members (MGI channels)
to be used for this "Networking" use. The default values should start with
member 1 = 3801, etc.
• MMC 820: Program the following values for LINK ID, SIGNAL G/W (enter the
MP10/MP10a IP address for each node), and IP type for each node as follows
(SELF refers to the current node you are programming):
Index Link ID
SELF 091
SYS01 092
• MMC 724: Set up the numbering plans. Trunk group 803 will contain all the IP
networking trunks.
STN NUM PLAN
TRKG NUMBER PLAN
FEAT Dial Number
NTWK LCR NUMPLAN
• MMC 210: Tenant On and Off: For LCR ENABLE: Set to ON to enable Least
Cost Routing. Set
• MMC 824: Set up the extension dialing plan for the networked system (node B).
092 is the node id for Node B. Be sure to set DISP=Y.
Index Station Converted SZ
01 21 09221
02 22 09222
03 23 09223
• MMC 714:
Entry Digit MOH
001 20** -
Signal G/W IP Type
192.168.1.2 Private
192.168.1.4 Private
Station numbers (2000 ~ 2099)
803 (Add other trunk groups here if other trunk cards
are installed. For simplicity, only 803 will be added
here.)
LCR 9 For C.O. outgoing calls, 9 + phone
number
IDX-01 : 21 Converted to 2100~2199 in MMC 824
IDX-02 : 22
IDX-03 : 23
ICM EXT FWD to ON.
Max MB
4 7 N
4 7 N
4 7 N
1~6 CW Delete Name
B - 0 -
2.8.12
Home Page
SPECIAL APPLICATIONS
PART 2 JANUARY 2009
DISP
Y Stations in Node B
Y
Y
Table of Contents