Fujitsu AUXB04GALH Service Manual page 249

10. FAN MOTOR removal
Remove the 5 mounting screws.
Remove the FAN GUARD
by sliding upward.
Cut the binders.(2 places)
Remove the 4 mounting screws.
Screws
Screws
Remove the nut.
And remove the PROPELLER FAN
Note at the installation.
Insert propeller Fan and Moter shaft reference
D cutting position.
And the tightening torque at the installation.
Tightening torque is from 10 to 12N m.
Binders
Loose the wire clamp, and
remove the lead wires.
Remove the FAN MOTOR.
Note at the installation.
Motor wire is underside of Fan motor.
06-09