Differential Inspection; Transaxle Housing Removal And Installation - Suzuki Liana RH418 Supplementary Service Manual

5A-120 Automatic Transmission/Transaxle:

Differential Inspection

1) Hold differential assembly with soft jawed vice and
set special tools as shown.
Special tool
(A): 09900–20607
(B): 09900-20701
2) Measure differential gear thrust play.
Differential gear thrust play
Standard: 0.06 – 0.22 mm (0.0024 – 0.0087 in.)
3) If thrust play is out of specification, replace thrust
washer with other selective washer shown in the
following so as thrust play to be in standard value.
Available differential gear thrust washer
thickness
0.95 mm (0.037 in.), 1.00 mm (0.039 in.), 1.05 mm
(0.041 in.), 1.075 mm (0.042 in.), 1.10 mm (0.043
in.), 1.15 mm (0.045 in.), 1.20 mm (0.047 in.)

Transaxle housing Removal and Installation

S3RH0B5106056
Removal
1) Remove oil seal (4).
NOTE
Never reuse removed oil seal.
2) Remove oil reservoir plate (1) with three magnets (2)
by removing bolts.
3) Remove cylindrical roller bearing retainer (3) by
removing bolt.
I2RH01510224-01
4) Remove counter shaft RH cylindrical roller bearing
(1), using special tools.
Special tool
(A): 09942-15511
(B): 09941-54911
(C): 09921-26010
NOTE
Never reuse removed cylindrical roller
bearing.
5) Remove counter shaft RH thrust roller bearing.
S3RH0B5106057
I2RH01510225-01
I2RH01510226-01