Overview Of Cycle Alarms - Siemens SINUMERIK 840D Programming Manual

03.96
04.00
5
5.3

Overview of cycle alarms

The alarm numbers are classified as follows:
6 _
• X=0 General cycle alarms
• X=1 Drilling, drilling pattern and milling cycle alarms
• X=6 Turning cycle alarms
The table below lists the errors that occur in the
cycles, when they occur and how to eliminate them.
Alarm number
61000
61001
61002
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
X _ _
Alarm text Source
"No tool offset LONGHOLE
active" SLOT1
SLOT2
POCKET1 to
POCKET4
CYCLE71
CYCLE72
CYCLE90
CYCLE93 to
CYCLE96
"Thread lead CYCLE84
incorrect" CYCLE840
CYCLE96
CYCLE97
"Machining type SLOT1
incorrectly defined" SLOT2
POCKET1
to POCKET4
CYCLE71
CYCLE72
CYCLE76
CYCLE77
CYCLE93
CYCLE95
CYCLE97
CYCLE98
Error Messages and Error Handling
5.3 Overview of cycle alarms
Explanation, remedy
D offset must be programmed before the
cycle is called
Check parameters for thread size and
check pitch information (contradict each
other)
The value assigned to parameter VARI
for the machining type is incorrect and
must be altered
5
5-283