Cycle Auxiliary Subroutines - Siemens SINUMERIK 840D Programming Manual

General
1
1.2 Overview of cycles
New in SW 5.2 and higher:
CYCLE73
Pocket milling with islands
CYCLE74
Transfer of pocket edge contour
CYCLE75
Transfer of island contour
New in SW 5.3 and higher:
CYCLE76
Mill a rectangular spigot
CYCLE77
Mill a circular spigot
Turning cycles
CYCLE93
Groove
CYCLE94
Undercut (form E and F according to DIN)
CYCLE95
Stock removal with relief cut
CYCLE96 Thread undercut (forms A, B, C and D according to
DIN)
CYCLE97
Thread cutting
CYCLE98
Chaining of threads
New in SW 5.1 and higher:
CYCLE950 Extended stock removal

1.2.2 Cycle auxiliary subroutines

The following auxiliary routines are part of the cycles
package
• PITCH and
• MESSAGE.
These must always be loaded in the control.
1-18
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
12.97
04.00
1
 Siemens AG 2000 All rights reserved.