Toshiba TDP-MT8 Service Manual page 27

Assembly Notes
♦
Make sure to install a fan mount on the diagonal corners of a replacement fan.
♦
Orient the fan so that the label faces the outward side of the bracket. Make sure cable emerges on
the top side of the fan nearest the center of the bracket.
♦
Torque the two screws to 6 in/lbs (.68 Nm).
♦
Make sure bottom and sides of the fan bracket engage the slots in the bottom case and the front vent.
The fan bracket fits into the bottom case only one way.
♦
Plug the cable from the fan nearest the lamp into connector J506on the controller ECA. The cable
from the fan nearest the power supply plugs into connector J517 on the controller ECA.
♦
Plug the cable from the left IR receiver into connector J508 on the controller ECA.
TDP-MT8 Service Guide 27