Troubleshooting - Panasonic KX-A405 Installation Manual

5 Troubleshooting

PROBLEM
•
The repeater does not turn
on.
•
Cannot register the
repeater. (The STATUS
LED and RSSI/ID LED
flash green and red
alternately.)
•
The PS is beeping.
•
Poor audio quality.
•
A ringing call suddenly
stops when moving
between CS/repeater
zones.
•
When talking and moving
between zones, you hear
an alarm or continuous
noise, or your call is
disconnected.
Document Version 2010-06
PROBABLE CAUSE
•
The AC adaptor is not
connected properly.
•
The CS is out of range.
•
The CS is not turned on.
•
The verification tone is
turned on.
•
The CS is out of range.
•
The PS is out of range.
•
There is a delay when
moving from a CS zone to a
repeater zone when
receiving a call in group ring
mode.
•
The new zone is "busy", so
handover cannot occur.
SOLUTION
•
Make sure that the AC adaptor is
properly connected to both the
repeater and the AC outlet.
•
Move the repeater closer to the CS and
repeat the registration procedure.
•
Confirm that the CS is on.
•
Turn the verification tone off.
•
Move the repeater closer to the CS.
•
Move the PS closer to the repeater.
•
Answer the call before moving between
CS/repeater zones.
•
Return to the original zone and
continue your call.
Installation Manual
5 Troubleshooting
19