Manual Registration - Panasonic KX-A405 Installation Manual

2 Registering the Repeater

Manual Registration

In manual registration, the repeater can be registered to another repeater to create a cascade configuration.
WARNING
When installing or testing a product with an external AC adaptor, the AC adaptor should be plugged
into a wall outlet or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted
AC outlet, as the weight of the adaptor may cause it to become disconnected.
1.
Ensure that the repeater is turned off by disconnecting the AC adaptor.
2.
Turn on the repeater by connecting the AC adaptor.
The STATUS LED will turn amber for 2 seconds.
3.
When the repeater is unregistered:
The STATUS LED will flash red, and the repeater automatically enters Easy Registration mode.
When the repeater is registered:
The repeater automatically enters Operation mode.
4.
Check the ID of the repeater you are attempting to register to (destination repeater).
a.
In Operation mode, press the destination repeater's PROGRAM button to switch to ID Confirmation
mode.
The ID is indicated by the number of times the RSSI/ID LED flashes green.
b.
Return the destination repeater to Operation mode by pressing the PROGRAM button again.
5.
On the repeater you are registering, press and hold down the PROGRAM button for 5 seconds to enter
Manual Registration mode.
The STATUS LED will flash amber.
The RSSI/ID LED will flash red once to indicate that the ID is currently set to 1.
6.
If the ID of the destination repeater was not 1, press the PROGRAM button to select the ID that matches
the destination repeater.
The ID can be selected from 1 through 6 by pressing the PROGRAM button. The ID will increase by one
each time the button is pressed.
7.
Press and hold down the PROGRAM button for 5 seconds to assign the ID to the repeater.
The RSSI/ID LED will turn red.
8.
Release the PROGRAM button to reset the repeater.
The STATUS LED will turn amber for 2 seconds and then start flashing red. The repeater will then start
searching for a repeater with the assigned ID.
9.
When the repeater has found a repeater with the assigned ID, the STATUS LED will turn green.
Registration is complete.
Note
If a repeater with the assigned ID cannot be found within 2 minutes, the repeater will automatically
reset and start searching for a repeater with the same ID again.
12 Installation Manual
Hook
Press plug firmly.
To AC Outlet
Document Version 2010-06