Panasonic CF-07 Series Reference Manual page 42

Dealing with Problems (Advanced)
Disk Operations
Cannot read/write to a
floppy disk
U n ab le to w rite to a
floppy disk
How to format a floppy
disk is unclear
Unable to read/write to
the hard disk
When the previous item
is not the cause
Trouble has occurred
with the disc
The access lamp does
not light
Cannot play disc or read
data from it
Cannot eject disc
A blue background ap-
pears on the screen with
the MPEG image
The CD-ROM drive vi-
brates excessively
Others
No response
Unable to install
Has the floppy disk been correctly inserted?
Has the floppy disk been correctly formatted?
Your floppy disk content may be corrupted.
Is the disk write-protected?
Select [Format] in [Start] - [My Computer] - [3 1/2 Floppy (A:)] - [File]. After confirming
the disk volume and format type, start formatting.
Your drive or file may not have been properly set.
Check to see if the hard disk is full. If it is full, delete unnecessary files.
Your hard disk content may be corrupted. Contact Panasonic Technical Support.
Try testing another drive or media.
You may need to clean the lens or disc.
Is the disc loaded on the tray correctly?
Is the disc bent, scratched, or dirty?
Is the computer powered on?
To remove a disc when the computer is powered off, insert a sharp object such as the
bent-out tip of a paper clip into the emergency hole. Pushing it completely to the end
will free the tray so that it can be pulled out.
Did you open the CD-ROM drive or remove the MPEG disc while it was operating?
Re-insert the MPEG disc and close the CD-ROM drive. Press Enter .
Is the disc bent labeled?
Check to see if the disc is inserted correctly, and check that the disc is in good
condition. If the disc is good and inserted correctly, set the [CD Drive Speed] to
[Low] in the Setup Utility. (
Press Ctrl + Shift + Esc to open Task Manager and close the software
application which is not responding.
After shutting down by pressing the power switch for more than four seconds,
press the power switch to power on and open the application again.
If the program no longer works normally, select [Start] - [Control Panel] - [Add or
Remove Programs] to delete the program using the following procedure. Then
reinstall the program.
Install the software after powering off the computer and the wireless display and then
connecting the port replicator, optional USB floppy disk drive, external keyboard and
external display.
Emergency Hole
page 32)
42