GE GTUP270EMWW Technical Service Manual page 65

Clear Error Codes
1. To clear error codes from the control memory; rotate the washer knob to position 4 and press and hold
the button. The indicators will fl ash during this process. Release the
START/ PAUSE
after 3 seconds.
2. Press and hold the
START/ PAUSE
exit diagnostic mode.
Note: Diagnostic mode will exit automatically after 15 minutes or a upon a power reset.
and buttons while rotating the knob to position 6 to
FABRIC SOFTENER
NOT USED
FABRIC SOFTENER BUTTON
SEE ERROR
ERROR CODES S
CODES TABLE
CLEAR CODES
MODEL CODE 27-in.
MODEL CODE 24-in.
ENTER / EXIT SERVICE MODE
SPIN AND SHIFTER SYSTEM S
DRAIN PUMP S
AGITATE S
HOT WATER VALVE S
COLD WATER VALVE S
START / PAUSE BUTTON S
– 65 –
button
START/ PAUSE