GE GTUP270EMWW Technical Service Manual page 61

CRITICAL FAIL MODE TABLE
LED STATUS
NOTE:
WHEN ONE OR BOTH CRITICAL
FAILURES OCCUR, THE WASHER IS
DISABLED.
IT IS NECESSARY TO ENTER SERVICE
MODE TO REESTABLISH THE
WASHER.
Two errors are deemed critical and will disable the machine until it is serviced. Other errors can self correct
and the machine will continue to operate. The critical errors occur with the safety lid lock or lid switch and
will be displayed to the consumer.
Lid switch failure is triggered by 3 consecutive wash/spin cycles where the control does not receive feedback
from the lid switch.
Lid lock failure is triggered by a single spin cycle where the control does not receive feedback from the lid
lock. The consumer can attempt to restart the machine but, if the failure still exists the machine will not run.
1 1 FS ON
* * WASH
0 0 RINSE
0 * SPIN
* 0 LID LOCKED
NO CRITICAL FAIL MODE TABLE
LED STATUS
* FLASHING
1 LED ON
0 LED OFF
– 61 –
1 1 FS ON
* 0 WASH
0 * RINSE
0 0 SPIN
0 0 LID LOCKED
(Continued Next Page)