Upgrading And Loading Settings Files - GE 239 Instruction Manual

Note
6.4.4

Upgrading and Loading Settings Files

Note
6–86
Courtesy of NationalSwitchgear.com
Locate the firmware file to load into the 239.
The firmware filename has the following format:
64 D 250 C4 000
Modification number (000 = none)
For GE Power Management use only
Product firmware revision (e.g. 2.50). On the 239, this number is
found in Actual Values page A3 under FIRMWARE VERSION/MAIN
PROGRAM VER
Required product hardware revision. This letter must match
the first character of the serial number located on the product
label on the back of the relay
Product Name (64 = 239 Relay)
The EnerVista 239 Setup software automatically lists all filenames beginning with
'64'.
Select the appropriate file.
Click OK to continue.
The software will prompt with another Upload Firmware Warning window. This will
be the final chance to cancel the firmware upgrade before the flash memory is
erased.
Click Yes to continue or No to cancel the upgrade.
The EnerVista 239 Setup software now prepares the 239 to receive the new
firmware file. The 239 will display a message indicating that it is in Upload Mode.
While the file is being loaded into the 239, a status box appears indicating how
much of the new firmware file has been transferred and how much is remaining,
as well as the upgrade status. The entire transfer process takes approximately five
minutes.
The EnerVista 239 Setup software will notify the user when the 239 has finished
loading the file.
Carefully read any displayed messages.
Click OK to return the main screen.
Cycling power to the relay is highly recommended after a firmware upgrade.
If the relay is not communicating with the EnerVista 239 Setup program, check your
communication settings by (a) checking the slave address and baud rate on the relay, or (b)
clicking on the Device Setup button on the main Enervista 239 screen and viewing the
communications parameters. Make sure that the Device Setup screen shows the new
firmware level. If not, click the Read Order Code button.
CHAPTER 6: User Interface
239 MOTOR PROTECTION RELAY – INSTRUCTION MANUAL