Hitachi HT-4139-48 Instruction Manual page 66

Paper Kind of papers
Quality
Non-carbon paper
Carbon paper lined sheet
Paper thickness
Number of Max number of characters / line
scanable
Max number of lines / page
characters
Max number of characters / page
Image Entry Input resolution
Bitonal image
Multiple value image
Multiple Streaming
Output Resolution
Drop out color
Writing utensils
Mixed sheet scanning
Imprinting
Front
Special mark print
Multi-Feed Transmitted light type
Detection
Ultra sonic sensor type
Hopper (Input tray) capacity
Stacker (Output trays) capacity
Dimension (W x D x H)
Mass
5-2
OCR paper / High qual. Paper / Regular paper※ / Recycled
paper※ / Sealed post card※
※ Not support B-paper
A-paper, C-paper
Not supported
2
41～174 g/m
Max 136 characters / line (Hand written / print)
Max 80 lines / page
Max 6,000 characters / page
Part / Whole image
OCR image : 200dpi
Image :100 / 150 / 200 / 300 / 400/ 600dpi
Half tone : 64 levels
Grayscale : 256 levels
Full color : RGB 8 bit each
Front: With a single scan, create
Max 3 kinds of images
50 - 600 dpi (When conversion of output resolution is specified.)
Single color: Red / Green / Blue
Multiple Colors
Pencil, Regular ball point pen (black), aqueous ball point pen
（Large / Small, Thin / Thick and OCR sheet / Non-OCR sheet
*3
Max 36 characters (one location)
Max 16 characters (two locations)
available ※ Protection of dual feed of papers that has not
good area for imprinting.
Some limitation for scanning mode.
Equipped
Equipped *4
2
）
55mm（550 sheets: 81g/m
Accept stacker: 55mm（550 sheets : 81g/m
Reject stacker: 10mm（100 sheets: 81g/m
Regular usage *5 485×700×405mm (approximately)
With extension tray: 485×700×540mm (approximately)
About 50 Kg (110 lb)
（※Pre-eval. is required）
Front / Back: With a single
scan, create
Max 3 kinds of images for
each sides
2
）
2
）