Setting By Country - Brother HL-1110 Service Manual

1.2

Setting by Country

(1) Check that the power switch is turned OFF with AC cord connected to the machine.
(2) Press and hold the
that the Ready and Error LEDs are lit. Open the top cover to check that the Error LED
goes out and only the Ready LED is lit.
Take out the drum unit and check that the Error LED is lit. Return the drum unit and
check that the Error LED goes out.
(3) Release the
(4) Press and hold the
Release the
after flashing several times.
(5) Connect the machine to your computer using the USB cable.
(6) Select "Start" > "All Programs" > "Accessories" > "Command Prompt" on your computer
and launch Command Prompt. The window shown below appears.
(7) Drag and drop the "SpecificationSetting.exe" file onto the "Command Prompt" window.
"Command Prompt" is shown as below.
(8) Refer to the next page to enter a space and country code right after
"¥SpecificationSetting.exe" shown in the command prompt, and press the [Enter
(Return)] key.
Setting by country is written to the machine.
(The figure above is for German model: HL-1110)
(9) Turn OFF the machine, and disconnect the USB cable.
(10) Turn ON the machine. Press the
state to print the Printer Settings.
button (keep holding the
button and check that all LEDs go out, and then close the top cover.
button at least two seconds and check that the Error LED is lit.
button and check that the Error LED goes out and the Ready LED is lit
button three times while the machine is in the ready
3-3
button for procedure (2)) and check
Confidential