Panasonic VL-SWD273 Important Information And Quick Manual page 14

6. VL-V900 basic operations
6.3 Main monitor operations with the lobby station
6.3.1 Image viewing screen of the main monitor
Image from lobby station
1
6.3.2 Monitoring the outside with the lobby station or camera
1
Press M N.
R If there are multiple devices, select the desired device →
R If a camera is connected to the lobby station, you can alternate monitoring between the lobby station and
camera by pressing
2
When finished, press M
Note:
R Depending on the composition of the system, monitoring may not be available.
6.3.3 Opening entrance doors
While talking to a visitor or monitoring with a lobby station or camera, press
6.3.4 Calling extension telephones
1
Press M N.
2
Select the desired extension telephone.
R Up to 4 extension telephones may be displayed.
3
→
Press
4
When finished, press M
6.4 System conditions and limitations
Please note the following system conditions and limitations.
R Only one call or monitoring session can be handled at a time.
Subsequent calls will disconnect the current call (if the current call has lower priority), or will not be connected (if
the current call has higher priority).
Low priority: Monitoring
Medium priority: General calls (lobby station to main monitor, main monitor to PBX extension, etc.)
High priority: Emergency calls
R All calls and monitoring sessions are disconnected after the pre-programmed "timeout" time elapses.
R In order to perform the above operations, optional devices and configuration for those devices are required.
Contact your building manager for more information.
14
Image from camera
1
Camera
or .
Lobby
Camera
N.
.
N.
Status icons
Indicates which lobby station is calling,
1
monitoring, or talking. ("1" indicates the
device number.)
Indicates which camera is monitoring.
1 1 ("1" indicates the device number.)
Indicates that the main monitor is
talking.
Lobby
Indicates that the main monitor is
monitoring.
.
.