Measuring Sockets - Siemens SINAMICS S120 Commissioning Manual

Starting/stopping the measuring function
With the corresponding measuring function parameter settings (e.g. offset), the motor can
"drift" and travel to its end stop.
The movement of the drive is not monitored while the measuring function is active.
To start the measuring function:
1. Ensure that the prerequisites for starting the measuring function are fulfilled.
2. Select the drive (as control board).
3. Set the measuring function
4. Load the settings to the target system ("Download parameterization" button).
5. Start the ramp-function generator ("Start measuring function" button).
To stop the measuring function:
● "Stop measuring function" button
Parameterization
The "measuring function" parameter screen is selected via the following icon in the toolbar of
the STARTER commissioning tool:
Figure 3-8
3.2.4

Measuring sockets

Description
The measuring sockets are used to output analog signals. Any interconnectable signal can
be output to any measuring socket on the Control Unit.
Commissioning
Commissioning Manual, (IH1), 07/2007 Edition, 6SL3097-2AF00-0BP7
CAUTION
– Activate the control board.
Drives –> Drive_x –> Commissioning –> Control board
– Switch on the drive.
Control board –> Activate enable signals –> Switch on
e.g. current controller setpoint change.
STARTER icon for "Measuring function"
Diagnosis
3.2 Diagnostics via STARTER
135