About The Operator's Manual - ABB REC670 Operator's Manual

Section 1
Introduction
1.1.2
12
manual should be used as a technical reference during the engineering phase,
installation and commissioning phase, and during normal service.
The Installation and Commissioning Manual (ICM) contains instructions on
how to install and commission the protection IED. The manual can also be used as
a reference during periodic testing. The manual covers procedures for mechanical
and electrical installation, energizing and checking of external circuitry, setting and
configuration as well as verifying settings and performing directional tests. The
chapters are organized in the chronological order (indicated by chapter/section
numbers) in which the protection IED should be installed and commissioned.
The Operator's Manual (OM) contains instructions on how to operate the
protection IED during normal service once it has been commissioned. The
operator's manual can be used to find out how to handle disturbances or how to
view calculated and measured network data in order to determine the cause of a fault.
The Engineering Manual (EM) contains instructions on how to engineer the IEDs
using the different tools in PCM600. The manual provides instructions on how to
set up a PCM600 project and insert IEDs to the project structure. The manual also
recommends a sequence for engineering of protection and control functions, LHMI
functions as well as communication engineering for IEC 61850 and DNP3.

About the operator's manual

Use the operator's manual for instruction on how to perform common tasks during
normal service.
The operator's manual contains the following chapters:
• The chapter "Safety information" presents warnings and notices, which the
user should pay attention to.
• The chapter "Overview" describes operations an operator may perform on a
daily basis or when the need arises.
• The chapter "Understand the local human-machine interface" describes how
to use the human-machine interface.
• The chapter "Understand the HMI tree" describes the different menu trees.
• The chapter "Read measured values" describes how to locate and identify
available measurement data.
• The chapter "Event list" describes the location and nature of recorded events.
• The chapter "Handle disturbances" describes how to retrieve disturbance
information and reset alarms.
• The chapter "Read and change settings" describes how to locate, and change
settings and parameters.
• The chapter "Diagnose IED status" describes the location and use of available
diagnostic tools.
• The chapter "Test the IED" describes the tests applicable to the IED.
• The chapter "Control and supervise the bay" describes how to use the Single
Line Diagram to open and close primary apparatuses.
1MRK 511 188-UEN C
Operator's manual