NEC UNIVERGE SV8100 Features & Specifications Manual page 354

Issue 5.0
assigned in Program 24-05 and Program 13-04. Once these programs are assigned, the access code
assigned in Program 11-11-27 can be used to change the destination as needed.
DND:
This feature can be enabled by using a (60) key programmed in Program 15-07 or by using service
codes assigned in Program 11-11-30 (set) and Program 11-11-31 (cancel). When this feature is
activated any DID pointed directly to the Pilot gets a busy tone and the call does not route.
User Log Out/Log In
An extension user can log out and log in to a Department Calling Group. By logging out, the user
removes their extension from the group. Once logged out, Department Calling bypasses their extension.
When they log back in, Department Calling routes to their extension normally. All users can dial a code
to log in or log out of their Department Calling Group. A multiline terminal can optionally have a function
key programmed to login/logout.
Enhanced Hunting
Department Calling is enhanced with expanded hunting abilities. Hunting sets the conditions under
which calls to a Department Group pilot number will cycle through the members of the group. The
hunting choices are:
Busy
A call to the pilot number hunts past only a busy group member to the first available extension.
Not Answered
A call to the pilot number cycles through the idle members of a Department Calling group. The call
continues to cycle until it is answered or the calling party hangs up. If the Department Group has
Priority Routing enabled, and the highest priority member is busy, the call does not hunt to the next
available extension.
Busy or Not Answered
A call to the pilot number cycles through the idle members of a Department Calling group. The call
continues to cycle until it is answered or the calling party hangs up.
1 - 344
UNIVERGE SV8100
Department Calling