6.7
Terminal function selection
6.7.1
f104 : Always active function selection 1
f108 : Always active function selection 2
f110 : Always active function selection 3
Function
[Parameter setting]
Title
f104 Always active function selection 1
f108
6
f110
Keeping an input terminal function always active (ON)
This parameter specifies an input terminal function that is always to be kept active (ON).
Function
Always active function selection 2
Always active function selection 3
Explanation of the coast stop function
When ST (Standby) is OFF, coast stops.
The default setting for ST (Standby) is ON. Please
change the following settings:
(no function)
Assign open input terminal 6: ST (Standby).
Coast stops if terminal set for ST (Standby) is set to
OFF. The monitor on the inverter at this time displays
Adjustment range
0-7, 10-153: Refer to section 11.6.
8,9: -
0-7, 10-153: Refer to section 11.6.
8,9: -
0-7, 10-153: Refer to section 11.6.
8,9: -
Motor
speed
F-CC
ST-CC
F-32
E6582175
Default setting
0 (No function)
0 (No function)
6 (ST)
Coast stop
ON
OFF
ON
OFF