Task 4: Set up the network interface
Prerequisites
Procedure
92
The following information is required to set up the D400 network interface:
•
D400's assigned IP addresses (Maintenance and
•
Subnet Mask
•
Gateway address (if applicable)
This set up must be done the first time from the D400's front serial communications port.
To configure the network interface:
1.
Connect to the front maintenance port. See "Task 1: Connect to the D400" on page 90.
2.
At the D400#>> command prompt, enter d400cfg.
Result: The D400 Configuration Utility Menu appears.
Figure 52: D400 Configuration Utility Menu
3.
Enter 3. Configure Network Interface.
Result: The Available Network Interfaces menu appears.
In a multiple network interface configuration you are prompted to enter which device
to configure (NET1 or NET2).
4.
Enter 1. Net1, or enter 2. Net2.
Result: The Network Interface: Net1 or Net2 menu appears.
5.
Enter 2. Static IP Address.
Result: You are prompted to enter the D400 IP address.
6.
Enter the appropriate Static IP Addresses:
6.1.
Enter 1. Configure Maintenance IP Address.
Note: This entry is mandatory.
Result: You are prompted to enter the D400 IP Address.
GE INFORMATION
CHAPTER 6: SETTING UP THE D400
D400 SUBSTATION GATEWAY INSTRUCTION MANUAL