Connecting To Interface Converter (Ks-485); Connecting To Interface Converter (K3Sc-10) - Mitsubishi Electric GOT1000 Series Connection Manual

5.5.6 Connecting to interface
converter (KS-485)

Communication settings
Make the communication settings using setting
switches.
Item
Transmission speed 9600bps
Terminating resistor
ON/OFF
*1
selection
*1 Set as necessary.

Settings by switch
RS-485
RS-232C
Front
(1) Settings of transmission speed and terminating
resistor selection
Setting item Set value
1
Transmission
9600bps ON OFF ON
speed
Terminating Enable
resistor
Disable
*1
selection
*1 Set as necessary.
*2 Disabled.
5 - 16
5. CONNECTION TO FUJI TEMPERATURE CONTROLLER
5.5 Temperature Controller Side Setting
Set value
Communication
setting switch
Rear
Switch No.
*2 *2
2 3 5 7
4 6
— ON —
ON
OFF OFF
5.5.7 Connecting to interface
converter (K3SC-10)

Communication settings
Make the communication settings by operating the DIP
switch of the temperature controller.
Item
Transmission speed
Data bit
*1
Parity bit
Stop bit
Communication Type
Echo back
*1 Make the same setting as that of GOT side.

Settings by DIP switch
8
Front of K3SC-10 body
(1) Transmission speed settings
ON
Transmission speed
(bps)
9600
19200
38400
Set value
*1
9600bps, 19200bps, 38400bps
8bits
Odd, even, none
1bit
RS-232C RS-485
Without
Inside of K3SC-10 body
(When removing the front cover)
Switch No.
1 2 3
Set these
OFF OFF OFF
switches.
ON OFF ON
OFF ON ON
Terminal block
for RS-422/485
communication
DIP switch
Terminal block
for RS-232
communication
SW
ON