Philips DV900VHS0I Owner's Manual page 33

Recording onaVideo Cassette Tape33
I Turn on the TV.
Readand follow the steps below to record a television program
onto a video cassette tape. Before you begin,make sure the Insert a tape in the
DVD/VCR is inVCR mode. Press the DVD/VCR OUTPUT button DVD/VCR.
so that the greenVCR light appears on the front of the DVD/VCR.
I
Turn on theTV and set it to channel 3 or 4, whichever chan-
nel the CH3/CH4 switch on the back of the DVD/VCR is set to.
Or, if you connected the DVD/VCR to the TV using audio and
video cables, select the correct audio and video in channel at the
TV. Details are on page 12.
2
Insert a tape with its record tab intact into the cassette
coml_artment of the DVD/VCR. If tape playback begins, press
the STOP button.
3
If the VCR/TV light appears on the front of the DVD/VCR, go to
step 4. If the VCR/TV light does not appear, press the VCR
button, then press the VCR/TV button once.
4
Press the SPEED button until the desired tape speed
appears briefly on the screen. (Detailsabout tape speedare on
page 38.)
5
Use the CHANNEL A/v buttons or the Number buttons
to select the "IV channel to be recorded.
6
Press the RECORD button once to start recording. The
RECORD light will appear.
7
To pause the recording, press the PAUSE button once.The
RECORD light will flash.To resume recording, press the
RECORD button or press the PAUSE button again. The
RECORD light will come on again.
8
To stop recording, press the STOP button.
3
5
6
PHILIPS
Helpful Hints
If you press the RECORD button
when there is not a tape in the
DVDIVCR,NO CASSETTEwill flash
on the screen.
If you press the RECORD button
while a tape without a record tab is
in the DVD/VCR,the DVD/VCR will
eject the tape and PROTECTED
CASSETTECANNOT RECORD will
flash on the screen.
Other recording optJonsare on
pages 34-40.
Youcan change the tape speed dur-
ing a recording,but some distortion
will appear on the tape.
The DVD/VCR will record in a preset
volume.