Toshiba e-STUDIO163 Service Manual page 188

(11) Remove the bushing on the rear side.
(12) Remove the oil seal.
(Replacement of Oil seal:
Replacement of Oil Seal")
[H] Replacement of Oil Seal
(1) Insert a fine screwdriver into the depression
of the oil seal to take it out.
(2) Push in a new oil seal parallel to the frame or
bushing (shown figure at right).
(3) Apply the grease (Alvania No.2; amount of 2
rice grains) on entire surface of the oil seal
evenly.
Note:
Wipe off the excessive grease.
e-STUDIO163/203 DEVELOPMENT SYSTEM
P.12-20 "[H]
12 - 20
Oil seal
Bushing
Fig. 12-34
Inside Outside
Grease
Fig. 12-35
December 2005 © TOSHIBA TEC
Oil seal