Table of Contents
Advertisement
※ ※ Lower Case and Base Plate size
Case Lower
– Refer to the dimension of the case below the power supply and fixate the product.
(Hole with width of 10mm)
Base plate to fixate product (Separately manufactured)
– Considering the safety of the system and installation, it is recommended to manufacture the
base plate separately to fixate the product. Refer to the following drawing.
(Not included in the product)
– If the base plate is not required, install the product by considering the cooling path
(Inlet/Outlet) of the system.
12,0
Bolt/Nut connection
255,0
30,0
231
10
252
▶ When manufacturing the base plate to fixate the
product, always use steel plate of L400xW272 (mm)
5T or above.
(Units : mm)
9
(Units : mm)
Inlet
13
Outlet
Advertisement
Table of Contents
