Siemens SINUMERIK 810D Commissioning Manual page 23

Menu: Exit
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
Changing BIOS settings
Once additional components have been installed or attached, it may be the case that the
system has to be informed of this via the BIOS setup:
1. Ramp up the device.
2. When the prompt to activate the BIOS setup appears, press the <F2> key (corresponds
3. The BIOS setup menu appears. In the menu, use the cursor keys to navigate to the
4. Change the setting using the <+> key (press <SHIFT> and <X> at the same time) or the
5. Using the left-right cursor keys, you can reach other setup menus.
6. Press <ESC> (<Alarm Cancel> key) to go to the "Exit" menu (or press the right cursor
7. Press the <Enter> key to exit the setup menu.
Then the system powers up.
Note
Changes to the BIOS settings, with the exception of the boot sequence, require an OEM
contract to be concluded.
PCU Basesoftware (IM6)
Commissioning Manual, 10/2006, 6FC5397-0DP10-0BA0
to horizontal softkey 2 on the OP).
desired selection box.
↔ key on in the numeric keypad.
key again).
Save changes on exit
Discard changes on exit
Load Setup defaults
Discard changes
Save changes
Commissioning a system
1.4 BIOS settings
1-19