Storing a Preset Position/Restoring a Preset Position
This section describes how to store a camera head angle, zoom position and
brightness level.
Up to six (1 to 6) preset positions can be stored. Turning the camera control unit's
main power switch and the base power switch OFF does not erase the stored preset
positions.
When the VC-C3 is in manual focus mode, the focus may be incorrect when
a preset position is restored. In this event, set the VC-C3 to auto-focus mode
or focus the VC-C3 manually.
Settings cannot be cleared.
To store a
To store a position
1. Set the camera head angle, zoom
position and brightness level.
The focus setting is not stored.
2. Press the
The base LED blinks green (at 0.5-second
intervals).
Press the
operation.
3. Press a button from
When the position has been stored, the base LED
stops blinking and remains lit green.
Any existing preset information is overwritten.
To restore a preset position
1. Press a button from
The VC-C3 returns to the stored camera head
angle, zoom position and brightness level.
position, the new information overwrites any existing settings.
button.
button again if you wish to cancel the
to .
to .
23