Protection; System Integration Precautions; Personnel Protection - Toshiba Q9 Installation And Operation Manual

Protection

• Ensure that primary protection exists for the input wiring to the equipment. This protection must be
able to interrupt the available fault current from the power line. The equipment may or may not be
equipped with an input disconnect (option).
• All cable entry openings must be sealed to reduce the risk of entry by vermin and to allow for
maximum cooling efficiency.
• If using multiple motors provide separate overload protection for each motor and use V/f control.
• It is the responsibility of the person installing the Q9 F
personnel to setup the Emergency Off braking system of the Q9 F
Emergency Off braking function is to remove output power from the drive in the event of an
emergency. A supplemental braking system may also be engaged in the event of an emergency. For
further information on braking systems, see DC Injection Braking in the Q9 ASD Installation and
Operation Manual.
Note:
• Follow all warnings and precautions and do not exceed equipment ratings.

System Integration Precautions

The following precautions are provided as general guidelines for the setup of the Q9 F
system.
• The Toshiba Q9 F
system design should take this into consideration. Please contact Toshiba's Customer Support
Center for application-specific information or for training support.
• The Toshiba Q9 F
will depend on observing certain precautions and performing proper system integration.
• A detailed system analysis and job safety analysis should be performed by the systems designer
and/or systems integrator before the installation of the Q9 F
Toshiba's Customer Support Center for options availability and for application-specific system
integration information if required.

Personnel Protection

• Installation, operation, and maintenance shall be performed by Qualified Personnel Only.
• A thorough understanding of the Q9 F
or maintenance of the Q9 F
• Rotating machinery and live conductors can be hazardous and shall not come into contact with
humans. Personnel should be protected from all rotating machinery and electrical hazards at all
times.
• Insulators, machine guards, and electrical safeguards may fail or be defeated by the purposeful or
inadvertent actions of workers. Insulators, machine guards, and electrical safeguards are to be
inspected (and tested where possible) at installation and periodically after installation for potential
hazardous conditions.
6
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
A supplemental emergency stopping system should be used with the Q9 F
Emergency stopping should not be a task of the Q9 F
S is a general-purpose product. It is a system component only and the
LOW AVER
S is part of a larger system and the safe operation of the Q9 F
LOW AVER
LOW
LOW
LOW
S will be required before the installation, operation,
LOW AVER
S .
AVER
Q9 FlowSaver Installation and Operation Manual
S or the electrical maintenance
AVER
S . The function of the
LOW AVER
S
LOW AVER
S alone.
AVER
S
LOW
S component. Contact
LOW AVER
.
AVER
S
LOW AVER