Connecting With Cleaner - Hitachi CJ 14DSL Handling Instructions Manual

(1) Loosen the base bolt by hexagonal
bar wrench attached on base and
move the base fully forward. (Fig. 22,
23)
(2) Align the scale (from 0 degrees to 45
degrees by 15-degree increments)
of the semi-circular part of the base
with the [ ] mark on the gear cover.
(Fig. 24)
(3) Tighten the M5 bolt again. (Fig. 22)
(4) Set the orbital position to "0".
NOTE
Angular cutting can not be done when adopting chip cover or
dust collector.

CONNECTING WITH CLEANER

By connecting with cleaner (sold separately)
through dust collector (sold separately) and
adapter (sold separately), most of dust can be
collected.
(1) Remove the hexagonal bar wrench from the
base.
(2) Move the base fully forward.
(Fig. 25, 26)
(3) Attach the chip cover.
(4) Connect the dust collector with adapter.
(Fig. 27)
(5) Connect the adapter with the nose of cleaner.
(Fig. 27)
Base
Base
bolt
Hexagonal bar wrench
Fig. 22
Base
bolt
Hexagonal bar wrench
Fig. 25
Chip
cover
Base
Dust collector
35
English
Forward
Fig. 23
-mark
Semi-circular part
Fig. 24
Base
Forward
Fig. 26
Nose
Adapter
Fig. 27
Base
Scale
Base
Cleaner