English
Cutting synthetic resins, such as phenol resin and vinyl chloride
○
Cutting thin and soft construction materials
○
Cutting stainless steel plate (with No. 97 blade)
○
BATTERY REMOVAL/INSTALLATION
1.
Battery removal
Hold the housing tightly and push the battery
latch to remove the battery (See Fig. 2).
CAUTION
Never short-circuit the battery.
2.
Battery installation
Insert the battery while observing its polarities
(See Fig. 2).
CHARGING
Before using the cordless jig saw, charge the battery as follows.
1.
Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's pilot
lamp will blink in red. (At 1-second intervals).
2.
Insert the battery into the charger.
Firmly insert the battery into the charger until the line is
visible, as shown in
Fig. 3, 4.
Rechargeable
battery
Pilot
lamp
<BSL1430>
28
Handle
Latch
Pull out
Insert
Fig. 2
Rechargeable
battery
Charger
Fig. 3
Line
Line
<BSL1830>
Fig. 4