Canon DP-V2420 Instruction Manual page 63

Item
Enable Switches the wave form monitor On, Off.
On, Off
Select Signal Sets the waveform to be displayed.
Y, Cb, Cr, R, G, B
Display Type Sets the display type. When "Line" is selected, data for one line is displayed.
All, Line
Selects the line to be displayed when "Line" is selected.
Select Line: 1 to 2160
Position Selects the display position.
Bottom Left, Bottom Right
Note
• This setting becomes invalid in the "Multi View (Dual)" display.
Scale Sets the scale of the wave form monitor.
Automatic: Sets the scale of the wave form monitor according to the Gamma setting.
IRE, Canon Log, Canon Log 2, Canon Log 3, SMPTE ST 2084: Select the scale.
Guide A guide is displayed at the specified position. "Guide" is not displayed when "255" is selected.
1 to 255
Standard Level Sets the standard display level (high). "Standard Level High" is not displayed when "255" is selected.
High 190 to 255
Standard Level Sets the standard display level (low). "Standard Level Low" is not displayed when "0" is selected.
Low 0 to 64
Color Sets the signals to be displayed and the color of signals exceeding the standard level.
Y, Cb, Cr, R, G, B: Selects the signal.
Selects the color of the selected signal.
White, Red, Green, Blue, Yellow, Cyan, Magenta
Default value of each signal is shown below.
Y (White), Cb (White), Cr (White), R (Red), G (Green), B (Blue)
Standard Level High, Standard Level Low: Selects the standard level.
White, Red, Green, Blue, Yellow, Cyan, Magenta
Default value of each standard level is shown below.
Standard Level High (Magenta), Standard Level Low (Cyan)
Setting Options (underline indicates factory default)
OSD Menu 63