Kenmore 106.8955 Series Use & Care Manual page 11

Tools Needed
Gather the required tools and parts before starting installation.
• 5/16"wrench • Flat putty knife
• 1/4" wrench • Phillips screwdriver
Hinge pin 5_6" hex-heoc/ hinge screw
Honc/le screw End cop screw
Remove Exterior Door Wrap and Handle
(on some models)
Door Stop and End-Cap Reversal
!
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug the ice maker or disconnect power.
2. Remove the hinge pin from the top hinge.
Top Hinge
A
A. Hex-heoc/ screws
1. Remove the handle screws and handle (on some models).
2. Remove the 2 hex-head screws located under the stainless
steel door wrap panel flange on the bottom of the door.
3. Pull up and outward on the door wrap panel from the
bottom.
4. Rotate the door wrap panel until it separates from the door
and pull up.
NOTE: Be sure the edge guards do not separate from the
door wrap panel.
A. Hinge pin
B. Phillips-heac/ countersink screw
C. Door stop
D. Hinge
E. Hex-heoc/ hinge screw
Bottom Hinge
0
A
@ IIIit1111 ................. 7
I I .! . ...........
E
B
c
D
A. Hex-heoc/ hinge screw D. Hinge pin
B. Door stop E. Hinge
C. Phi//ips-heoc/ countersink screw
11