ABB 800xA Operation page 160

HXAM_ST_Faceplate
and Delta P Cold will show
otherwise, except when the Status field says
-1
The fields in the Pressure tab are:
•
•
160
Delta P Hot Monitor:
– Status: This field gives the status of the Delta P Hot Monitor. The
different status that one might see here are as follows:
Enabled: If Delta P Hot Monitor is enabled.
Not Enabled: If Delta P Hot Monitor is not enabled.
Stale Data in Trained Set: If one or more BOPS is stale.
Not Available: During Training.
Data Unavailable: If Delta P Hot Monitor is but Delta P Hot data is not
available.
– Limit Reached: Gives the subcondition for the
Delta_P_Hot_Operating_Point condition. The different subconditions that
will be reported during Monitoring are:
Normal: Delta P Hot is within the Normal range.
Increasing: Delta P Hot has crossed the Delta_P_ Hot _Increasing Limit.
High: Delta P Hot has crossed the Delta_P_Hot _High Limit.
Decreasing: Delta P Hot has crossed the Delta_P_Hot _Decreasing Limit.
Low: Delta P Hot has crossed the Delta_P_ Hot _Low Limit.
– Delta P Hot: Gives the value of Delta P Hot for the current OPS.
Delta P Cold Monitor:
– Status: This field gives the status of the Delta P Cold Monitor. The status
values are:
Enabled:
Not Enabled:
Stale Data in Trained Set: If one or more BOPS is stale.
Section 9 Heat Exchanger Asset Monitor (HXAM)
when the Asset Monitoring Server is not running and
0
Enabled
If Delta P Cold Monitor is enabled.
If Delta P Cold Monitor is not enabled.
.
3BUA000150-600