Uefi Setup Menu Items (Cb 520X B2); System Configuration And Boot Management - Hitachi Compute Blade 500 Series User Manual

Load Default Settings
Select Load Default Settings and press Enter to cancel the change in
settings and to restore to the factory default settings.
Note: The following phenomena occur when a server blade carries Broadcom
1Gb 4p/8p LAN mezzanine cards. When you execute "Load Default Settings"
on CB 520X B1 EFI BIOS menu, messages below are displayed separately.
Press the Enter key until messages are not displayed. For 1 port, a message
is displayed 1 or 3 times. In the case of 1Gb 4p mezzanine card, you will
need to press the enter key 4 or 12 times in total.
Exit Setup
Select Exit Setup and press Enter to exit from the setup menu.
When the dialog to select either you want to exit setup menu or return to
setup utility appeared, press Y to exit the setup menu.
Tip: If you have unsaved changes, <Y> Save And Exit the Setup Utility is
appeared. And then press Y to save changed settings and exit.

UEFI setup menu items (CB 520X B2)

This section describes UEFI setup menu items for CB 520X B2.

System Configuration and Boot Management

Select an item to display or set, and press Enter.
The following table shows description of menu items displayed in the left side
of the window.
UEFI setup menu
Hitachi Compute Blade 500 Series EFI User's Guide
2-109