Motorola nvg589 Administrator's Hanbook page 151

set physical dsl profile-8c [ on | off ]
Enables or disables VDSL2 profile 8c governing upstream and downstream bandwidth. Default is on.
set physical dsl profile-8d [ on | off ]
Enables or disables VDSL2 profile 8d governing upstream and downstream bandwidth. Default is on.
set physical dsl profile-12a [ on | off ]
Enables or disables VDSL2 profile 12a governing upstream and downstream bandwidth. Default is on.
set physical dsl profile-12b [ on | off ]
Enables or disables VDSL2 profile 12b governing upstream and downstream bandwidth. Default is on.
set physical dsl profile-17a [ on | off ]
Enables or disables VDSL2 profile 17a governing upstream and downstream bandwidth. Default is on.
set physical dsl profile-30a [ on | off ]
Enables or disables VDSL2 profile 30a governing upstream and downstream bandwidth. Default is off.
set physical dsl bit-swap [ on | off ]
Turns DSL bit-swapping on or off. Bit-swapping is resilient to loss of hand-shake commands. Default is on.
set physical dsl trellis [ on | off ]
Turns trellis error correction encoding on or off. Default is on.
set physical dsl vectoring-enable [ off | on ]
Enables or disables VDSL2 vectoring. Vectoring enables VDSL2 to achieve its highest potential data rates,
exceeding 100 Mbps. Default is off.
set physical dsl vectoring-timeout-ms milliseconds
If vectoring-enable is set to on, specifies a timeout interval in milliseconds. Default is 5000.
set physical dsl nlnm-threshold [ 0 - 480 ]
Specifies the New Low Noise Model (NLNM) value between 0 and 480. Default is 60.
set physical dsl transport [ atm | ptm | auto | off ]
Sets the DSL transport mode: Asynchronous (atm), Packet (ptm), Automatic (auto), or none (off). Default is ptm.
set physical dsl atm vcc 1 enable [ off | on ]
Turns atm on or off on vcc 1. Default is on.
151