Dhcp Option Customization Configuration Example - HP FlexNetwork MSR2003 Configuration Manual

Figure 28 Network diagram
DHCP client
Configuration procedure
# Enable DHCP.
<RouterA> system-view
[RouterA] dhcp enable
# Configure the primary and secondary IP addresses of interface GigabitEthernet 2/0/1, and enable
the DHCP server on GigabitEthernet 2/0/1.
[RouterA] interface gigabitethernet 2/0/1
[RouterA-GigabitEthernet2/0/1] ip address 10.1.1.1 24
[RouterA-GigabitEthernet2/0/1] ip address 10.1.2.1 24 sub
[RouterA-GigabitEthernet2/0/1] dhcp select server
[RouterA-GigabitEthernet2/0/1] quit
# Create DHCP address pool aa.
[RouterA] dhcp server ip-pool aa
# Specify the primary subnet and the gateway for dynamic allocation.
[RouterA-dhcp-pool-aa] network 10.1.1.0 mask 255.255.255.0
[RouterA-dhcp-pool-aa] gateway-list 10.1.1.254
# Specify the secondary subnet and the gateway for dynamic allocation.
[RouterA-dhcp-pool-aa] network 10.1.2.0 mask 255.255.255.0 secondary
[RouterA-dhcp-pool-aa-secondary] gateway-list 10.1.2.254
[RouterA-dhcp-pool-aa-secondary] quit
[RouterA-dhcp-pool-aa]
Verifying the configuration
# Verify that the DHCP server assigns clients IP addresses and gateway address from the secondary
subnet when no assignable address is available from the primary subnet. (Details not shown.)
# On the DHCP server, display IP addresses assigned to the clients.
[RouterA] display dhcp server ip-in-use

DHCP option customization configuration example

Network requirements
As shown in
server (Router A). The subnet for address allocation is 10.1.1.0/24.
Router A
DHCP server
GE2/0/1
10.1.1.1/24
10.1.2.1/24 sub
...
DHCP client DHCP client
Figure 29, DHCP clients obtain IP addresses and PXE server addresses from the DHCP
Gateway
63