Upper Cover, Ink Cartridge Cover And Media Module Cover - Brother DCPJ525W Service Manual

9.10 Upper Cover, Ink Cartridge Cover and Media Module Cover

(1) Open the ink cartridge cover.
(2) Remove the five screws (four screws if the front cover has been removed in the previous
section) from the upper cover.
(3) Hold the right and left sides of the upper cover and lift it up and off the lower cover.
Note: Do not put your hands into the opening above the platen (shown below). Doing so
may damage or stain the CR encoder strip inside.
Opening above the platen
Upper cover
CR encoder strip
PF encoder disc
Assembling Notes:
• When mounting the upper cover:
- Make sure that the ink cartridge cover is opened.
- Make sure that the head/carriage unit is placed in the head capping position (home
position). This prevents the ink supply tubes from getting crushed between the upper and
lower covers.
(If the head/carriage unit remains removed in
supply tubes or carriage flat cables between the upper and lower covers.)
- Take care not to deform the PF encoder disc.
- Be sure to fit the hooks provided on the inside of the upper cover into the groove in the
lower cover.
• After mounting the upper cover, check that the PF encoder disc is not bent or deformed.
*
Hooks
Lower cover
Section
3-76
Taptite, bind B
M4x12
* This screw has been removed
for removal of the front cover
in Section 9.9.
Hooks
Ink cartridge cover
9.3, take care not to crush the ink
(3_072)
Confidential