HP MSR4080 Configuration Manual page 80

Figur e 22 Network diagram
Configuration procedure
1. Configure IP addresses for each interface. (
2. Configure a BG
on Router A.
<RouterA> system-view
[RouterA] bgp 1000
[RouterA-bgp]
[RouterA-bgp] peer 168.1.1.2 connect-interface GigabitEthernet 2/1/1
[RouterA-bgp] addres
[RouterA-bgp-ipv4] import-route direct
[RouterA-bgp-ipv4] peer 168.1.1.2 enable
[RouterA-bgp-ipv4] quit
[RouterA-bgp] quit
3. Configure Router B:
# Configure a BGP connection to Router A, apply the routing polic
168.1.1.1, and add the network 2.2.2.0/8 to the
<RouterB> system-view
[RouterB] bgp 2000
[RouterB-bgp] peer 168.1.1.1 as-number 1000
[RouterB-bgp] peer 168.1.1.1 connect-interface
[RouterB-bgp] address-family ipv4
[RouterB-bgp-ipv4] peer 168.1.1.1 enable
[RouterB-bgp-ipv4] peer 168.1.1.1 route-p
[RouterB-bgp-ipv4] quit
[RouterB-bgp] quit
# Configure the routing policy qppb.
[RouterB] route-policy qppb
[RouterB-route-policy-qppb-0] apply ip-precedence 1
[RouterB-route-po
[RouterB-route-policy-qppb-0] quit
# Enable QPP
[RouterB] interface gigab
[RouterB-GigabitEthernet2/1/1] bgp-po
[RouterB-GigabitEthern
# Configure a QoS policy.
[RouterB] traff
[RouterB-cl
[RouterB-cl
P connection to Router B, and add the network 1.1.1.0/8 to the BGP routing table
peer 168.1.1.2 as-number 2000
s-family ipv4
permit node 0
licy-qppb-0] apply qos-local-id 3
B on interface GigabitEthernet 2/1/1.
itethernet 2/1/1
et2/1/1] quit
ic classifie r qppb
assi fier-qppb] if-match ip-precedence 1
assifier-qppb] if-match qos-local-id 3
Details not shown.)
BGP routing table.
GigabitEthernet 2/1/1
olicy qppb import
licy source ip-prec-map ip-qos-map
78
y qppb to routes from the peer